Is there a way to completely nuke cam from my system. it might be the cable also i had a dead internal usb to micro usb that came with the hue+ i had to do this for my HUE+ since i didnt have any MB 2.0 headers left. Run a usb micro cable to usb from inside the case to the I/O on the MB for the HUE+ unless you want to do it for the cooler i dont know what connector they use. if the cpu cooler still doesnt show up ,switch the headers if then the cooler works but not hue+ your port is dead. restart the pcĭownload cam but do not install do a second restart but check again for left over files. Thanks again.ĭo a clean install delete cam then check %APPDATA% for any files left over nuke them. I'm not sure if the website should be trusted so I wanted a second opinion before I moved on. I quickly Googled where I could find the drivers and I found them from this website below. I mainly just wanna change the color of it but also play around with the pump and fan settings later. The NZXT logo shows up white and I can hear the motor silently hum along with the decreased temperatures of my CPU, but I just can't change the settings. I found out that this might interfere with it so I unplugged the fans and the only fans running in my system are the two on the radiator which are plugged into the unit and one in the back plugged directly into the motherboard. The unit features four 4-pin fan headers which I plugged the two from the rad in and two from the front of my case in so that I could get rid of my fan hub. I've done this numerous times and it still hasn't moved the 690LC driver from the Unspecified column and the drivers aren't installed for the Kraken. I hit troubleshoot and after saying that it wasn't installed it had me restart my PC. I did some research and found out that this is indeed the Asetek driver needed for the Kraken to work.

I went to my devices and printers and found a missing driver called 690LC. I've hit the little gear at the top of the window and hit 'Install NZXT Drivers' and clicked on Kraken, but when it says that the drivers were installed nothing happens to CAM. However I can't seem to install the drivers for the AIO liquid cooler. I also got a Hue+ and when I booted up CAM it recognized the Hue+ immediately and installed the drivers for it. Alright so yesterday I installed my Kraken 圆1 AIO liquid cooler from NZXT which is able to be controlled via NZXT's CAM software.

Asetek usb device 690lc driver